Cleaning The Charger - Medtronic Guadrian Link 3 Bedienungsanleitung

Note: During testing, Medtronic MiniMed used Detachol
residue from the transmitter. Detachol™* is recommended for use but may not be
available in all countries.
To remove adhesive residue:
1 Make sure the tester is attached to the transmitter.
2 Soak a cotton swab in the medical adhesive remover.
3 Hold the tester and gently rub the adhesive remover on the transmitter until the
residue is removed.
4 Continue with the cleaning procedure. See Cleaning the transmitter, on page 9 for
details.
Bathing and swimming
After the transmitter and sensor are connected, they form a waterproof seal to a depth of
2.4 meters (8 feet) for up to 30 minutes. You can shower and swim without removing
them.

Cleaning the charger

This procedure is for general cleaning as required, based on physical appearance.
CAUTION: Do not immerse the charger in water or any other cleaning agent. The
charger is not waterproof. Water can damage the charger and cause the
device to malfunction.
WARNING: Dispose the charger according to the local regulations for battery
disposal, or contact your healthcare professional for disposal
information. The charger may ignite upon incineration.
To clean the charger:
1 Wash your hands thoroughly.
™*
to remove the adhesive
-18-