Husqvarna 520iLX Bedienungsanweisung Seite 14

a) The product is switched on when the LED (B) is
lit.
b) The product is switched off when the LED (B) is
out.
2. See Troubleshooting on page 22 if the warning
indicator (C) is lit or flashes.
To do a check of the power trigger lockout
The power trigger lockout is designed to prevent
accidental operation. When you press the lock (A) it
releases the power trigger (B). When you release the
handle, the power trigger and the power trigger lockout
both move back to their original positions. This
movement is operated by independent springs.
B
1. Make sure that the power trigger is locked when the
lock is in its original position.
2. Press the power trigger and make sure it returns to
its original position when you release it.
14
A
3. Make sure that the power trigger and the lock moves
freely and that the return spring works properly.
4. Start the product, see
19 .
5. Apply full throttle.
6. Release the power trigger and make sure that the
cutting attachment stops and remains still.
To do a check of the cutting attachment guard
WARNING:
cutting attachment
without an approved and
correctly attached cutting
attachment guard.
Always use the
recommended cutting
attachment guard for the
cutting attachment that
you use, see
Accessories on page
25 . If an incorrect or
faulty cutting attachment
guard is attached this
can cause serious
personal injury.
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the motor.
To start the product on page
Do not use a
756 - 007 -