Restoring The Default Settings; Registering And Deregistering Handsets - AUDIOLINE DECT 8048 -SOS Bedienungsanleitung

8.12

Restoring the default settings

This function resets the handset and base station settings to their status on leaving the factory. The phone book,
caller list (CLIP) and all phone numbers in the redialling list are deleted.
Default settings:
Language: English
Battery warning tone: On
Range warning signal: On
Key tone: On
Receiver volume: 3
Pin code: 0 0 0 0
Pause : 3 sec.
Dialling method: DTMF/Tone
1. Press the Menu button
D E
2. Use and
D E
3. Use and
4. Enter the PIN code (default setting 0000) via the digit keys and confirm by pressing
CONFIRM? appears.
5. Confirm by pressing the Menu button
6. The default settings are restored after a short time. The display then indicates the equipment is ready to
operate.
If you forget the PIN code, you can reset the default settings without the PIN code.
Note:
1. Remove the battery from the handset.
2. Press and hold the
appears in the display.
3. Confirm by pressing
time by pressing the
8.13

Registering and deregistering handsets

A further handset can be registered on the base station. The maximum number of registrations is 4 handsets or 3
handsets and 1 alarm unit.
66
- Advanced Functions -
B
.
to select the SETUP menu and confirm by pressing
to select the DEFAULT function and confirm by pressing
B
*
button and insert the battery again. Press and hold the
B
and the default factory settings are reset. The process can be cancelled at any
F
button.
Name of handset: DECT8048
Automatic answering: On
External ringing melody: 3
Internal ringing melody: 1
Ringing volume, handset: 3
Ringing melody, base station: 2
Ringing volume, base station: 3
Recall (Flash) time: 100 ms
.
B
.
B
.
B
. The message
*
button until DEFAULT