Setting The Coding Switch; Commissioning Of The System And Module - Buderus EM100 Installationsanleitung

4.1

Setting the coding switch

Coding switch with On/Off indicator of the module and a status
display of the connected heat sources or modules:
Fig. 5 Coding switch with module status display, and a status
display of the connected heat sources or modules
Coding Function of module
1)
0 –

1

2
2)

3
2)

4

5
3)
6-10 –
1) Off (delivered condition)
2) In the case of simple systems, which operate with the
standard settings, no control unit RC310 is necessary in
positions 3 and 4. This is optional.
3) Unused
Table 6 Coding and function
22
4 5 6
3 7
2 8
1 9
10
0
– – – –
  
–
 
– –
 
– –
 
– –

– – –
– – – –
4.2

Commissioning of the system and module

If a control unit is connected, start the automatic configuration
wizard.
NOTICE:
Danger of data loss in combination with MC400
0 010 013 313-001
Follow the sequence during commissioning.
▶ First put heat source into operation with EM100, then put
MC400 into operation.
If RC310 is reconnected from MC400 to heat sources with
EM100 and vice versa, the system settings are lost. Renewed
commissioning is required.
▶ To set the EM100, follow the sequence during
commissioning ( Notice).
▶ To set the EM100 subsequently, use separate RC310 as
service tool.
–
–

–
–
–
–
EM100 – 6721804147 (2019/10)