General Safety Instructions - Buderus EM100 Installationsanleitung

1.2

General safety instructions

H Notices for the target group
These installation instructions are
intended for gas, plumbing, heating and
electrical contractors. All instructions
must be observed. Failure to comply
with instructions may result in material
damage and personal injury, including
danger to life.
▶ Read the installation instructions
(heat source, heating controller, etc.)
before installation.
▶ Observe the safety instructions and
warnings.
▶ Follow national and regional
regulations, technical regulations and
guidelines.
▶ Record all work carried out.
H Determined use
▶ Use the product only to control
heating systems.
Any other use is considered
inappropriate. We take no responsibility
for damage caused through incorrect
use.
H Installation, commissioning and
maintenance
Installation, commissioning and
maintenance must only be carried out by
a competent person.
▶ Never install the product in wet
rooms.
▶ Only use genuine spare parts.
EM100 – 6721804147 (2019/10)
H Electrical work
Electrical work must only be carried out
by a qualified electrician.
▶ Before starting electrical work:
– Isolate all poles of the mains power
supply and secure against
reconnection.
– Make sure the mains voltage is
disconnected.
▶ The product requires different
voltages.
Do not connect the extra-low voltage
side to the mains voltage or vice
versa.
▶ Also observe the connection
diagrams of other system
components.
H Handover to the user
When handing over, instruct the user
how to operate the heating system and
inform the user about its operating
conditions.
▶ Explain how to operate the heating
system and draw the user's attention
to any safety relevant action.
▶ In particular, point out the following:
– Alterations and repairs must only
be carried out by an approved
contractor.
– Safe and environmentally
compatible operation requires
inspection at least once a year and
responsive cleaning and
maintenance.
15