Loading Fanfold Paper - Star LC-100+ COLOUR Bedienungshandbuch

Rear cover
Capot arrière
Traktorabdeckung
Coperchio posteriore
15
Release lever
Levier de dégagement
Papierwahlschalter
Cut-sheet
Leva di rilascio
Feuilles séparées
Einzelblätter
Carta in fogli
Fanfold
Papier continu
Endlospapier
Carta in modulo continuo

Loading fanfold paper

This section tells you how to load fanfold paper. Note
that you can also use cut-sheet paper and multi-paper
form paper. For details on using other types of paper,
see "Paper Handling" on page 111 of this manual.
Remove the paper guide from the printer.
Position the stack of paper behind the printer.
Make sure printer power is turned off.Set the
release lever to the fanfold position.
Grasping the two back corners of the printer with
the palms of your hands, press back on the two
raised areas on the top of the rear cover until it
opens.
Swing the rear cover back and down until it stops.
Note:
You can also completely remove the rear cover by
simply pulling it away from the back of the printer
after you open it.
Pass the fanfold paper through the space between
the printer case and the rear cover.
Unlock the two tractor covers by pushing their
gray levers down, and slide them so they are
aligned approximately with the holes on the sides
of the paper. Also move the center paper support
so that it is approximately halfway between the
two tractors.