Inhaltsverzeichnis
Werbung
User's manual
Manuel de l'utilisateur
Bedienungsanleitung
Manuale dell'utilizzatore
Ribbon cassette
Cartouche de ruban
Farbbandkassette
Cartuccia del nastro
Front cover
Capot avant
Frontabdeckung
Coperchio anteriore
Power switch
Interrupteur d'alimentation
Netzschalter
Interruttore di alimentazione
Control panel
Panneau de commande
Bedienfeld
Pannello comandi
3
3.5" Floppy disk
Printer
Disquette 3,5"
Imprimante
3,5-Zoll-Diskette
Drucker
Floppy disk da 3,5"
Stampante
Entry slot
Fente d'entrée du papier
Papiereinzug
Adjustment lever
Feritoia di ingresso
Levier de réglage
Kopfspalt-Einstellhebel
Paper guide
Leva di regolazione
Guide-papier
Papierführung
Guida della carta
Release lever
Levier de dégagement
Papier wahlschalter
Leva di rilascio
Platen knob
Molette du cylindre
Walzendrehknopf
Print head
Manopola del rullo
Tête d'impression
Interface connector
Druckkopf
Connecteur interface
Testina di stampa
Schnittstellenanschluß
Connettore interfaccia
Platen knob
Molette du cylindre
Walzendrehknopf
Manopola del rullo
Paper guide
Guide-papier
Papierführung
Guida della carta
Rear cover
Capot arrière
Traktorabdeckung
Coperchio posteriore
Tractors
Tracteurs
Stachelwalzen
Trattori
Bail lever
Levier du presse-papier
Freigabehebel
Ribbon cassette
Leva libera-carta
Cartouche de ruban
Farbbandkassette
Cartuccia del nastro
Unpacking the printer
Check to make sure that the carton contains each of
the items shown in the following illustration.
If anything is missing, contact the store where you
bought the printer and ask them to supply the missing
part. Note that it is a good idea to keep the original
box and all the packing materials just in case you
need to pack the printer up again and send it
somewhere at a later date.
A serial-to-parallel interface converter (SPC-8K), an
Automatic Sheet Feeder (SF-10DT) and monochrome
ribbon cassettes (LC9/LC9HD/LC9W) are also
available as options. Consult your dealer for details.
Important!
There are several versions of this printer designed
for different voltages. It is not possible to change the
voltage of a printer. If the voltage shown on the label
on the bottom of your printer does not match the
voltage for your area, contact your dealer
immediately.
General guide
The following illustrations show the major
components of the your printer.
Werbung
Inhaltsverzeichnis
Fehlerbehebung
