Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BT
1
2
3
Stationary Transmitter for
Audio Signals
These instructions are intended for users with knowl-
edge of wireless audio transmission technology.
Please read the instructions carefully prior to opera-
tion and keep them for later reference.
1
Overview
1.1 Front panel
1 Button BT to pair the transmitter with a Blue-
tooth signal source (chapter 6.1)
2 On / off switch
ON: Keep the button pressed for 2 seconds
until the display is illuminated.
OFF: Keep the button pressed for 4 seconds
until the display indicates OFF.
3 3.5 mm jack
combination
4 Volume control EAR VOL for the headphones
The headphones can be used to monitor the AUX
1
signals [signals of the inputs LOOP IN (13), AUX IN (15)
and the Bluetooth receiver].
5 Button FEED: To send the microphone signal
[from the jack
ton so that the button is illuminated.
6 Volume control MIC LEV for the input signals
sent from the jacks
7 Display
a
g
En
lish T01
CH 01
d
e
f
a channel name to be defined as desired
b ID number
can be entered by means of the software "System
2
Compiler OSW" provided
c level indication AF ("audio frequency") for the
audio signal transmitted
12
ATS-80ST
ON
0 0
10
0
10
EAR VOL
MIC LEV
FEED
4
5
6
for the headphone /microphone
provided
1
(3) or MIC (16)], press the but-
(3) and MIC (16)
b
c
AF
Lo
➂
g
h
i
2
AF
CH 40
7
d operating mode selected (chapter 5)
default setting:
e transmitter power selected (chapter 5)
default setting:
f communication mode: "Discussing" (fixed
setting)
g transmission channel (CH 01 – 42)
h input level of the AUX signals
default setting: "Lo"
i lock symbol
8 Control knob SET to set the transmission channel
(chapter 5.3) and to make the basic settings
(operating mode, transmitter power, input
level, chapter 5); to indicate the transmission
frequency instead of the channel number (g),
press the knob briefly
9 Button FEED THRU: To transmit the AUX signals
press the button so that it is illuminated.
10 Volume control AUX LEV for the AUX signals
transmitted
1
AUX signals = signals of the jacks AUX IN (15), LOOP
3
IN (13) and the Bluetooth receiver
1.2 Rear panel
11 Jack for the transmitter antenna provided
12 Output LOOP OUT (6.3 mm jack): The signals
of the jack LOOP IN (13) are available at this
output and can be routed to a second ATS-80ST,
for example.
13 Input LOOP IN (6.3 mm jack): Line level signals
can be fed to this input. These signals can be
monitored via headphones and are available at
the jack LOOP OUT (12) for being routed to an-
other device. If the signals are not to be transmit-
ted (e. g. the source language for simultaneous
interpreting), make sure that the button FEED
2
THRU (9) is not illuminated.
14 Output MIX OUT (RCA jacks): The (mono) audio
signals to be transmitted are available at this
output. These signals can be routed to a recorder
or an amplifier, for example.
SET
Lo
ON
FEED THRU
8
9
= "Transmitter"
= "Hi"
3
= channel setting is locked
0
10
AUX LEV
➀
10
(chapter 5)
,
3
3
Werbung
Inhaltsverzeichnis
