IKEA Frostig Bedienungsanleitung Seite 17

ENGLISH
Problem
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
There is too much con-
densed water on the rear
wall of the refrigerator.
Possible cause
Food products prevent
water from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Shopping is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products temper-
ature is too high.
Many food products were
inserted at the same time.
The door has been
opened too often.
The Shopping is switched
on.
There is no cold air circula-
tion in the appliance.
Door was opened too fre-
quently.
Solution
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off Shopping manually,
or wait until the function resets
automatically to set the tem-
perature. Refer to " Shop-
ping".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Insert less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Shopping".
Make sure that there is cold
air circulation in the appliance.
Open the door only when nec-
essary.
17