Peel Counter Function; Cleaning; Important Notice - Zummo Z40 Nature ONE Bedienungsanleitung

4.4. PEEL COUNTER FUNCTION

The machine has an automatic system for warning when the peel collection container is full. If
you want to activate this function, please proceed as follows:
 Turn off the machine's power switch.
 With the machine off, press SELECT, and continue pressing while turning the power
switch back on. Keep pressing for four seconds until you see the containers/chutes
appear on the display panel alongside a three-digit figure.
 Once this screen appears you need to enter the number of peels the machine needs to
produce before the alarm goes off. By pressing SELECT intermittently, the number of
peels will continue to increase. If, on the other hand, you press SELECT continuously for
more than two seconds, the number will start reducing.
 Once the number of peels has been selected, press STOP and that quantity will be held
in the machine's memory.
 Once the machine reaches the desired quantity it will stop and the two containers /chutes
on the display panel will blink. To continue juicing, the peel deposit must be emptied and
then the ON button pressed in order to reset the counter.
TO DEACTIVATE THE PEEL COUNTER.
Repeat the previous operation and set the counter to zero.

4.5. CLEANING

The machine squeezing area and parts must be cleaned daily.

Disconnect the machine turning the power switch off (Fig. 5). Then the digital display will turn
off (Fig. 6).

Remove one of the side panels, activating the locking system and gently pulling the back
section upwards (Fig. 7).

Remove the cover by dismantling it from the remaining side section (Fig. 8) and clean it with
a damp cloth moistened in a neutral soapy solution (IMPORTANT! NEVER use abrasive
products which might scratch it).

Remove the remaining side section as before.

Unscrew the nuts of the shafts of the tray and pull outwards horizontally to remove the Self
Service tray and the filter (Fig. 9).

Remove the squeezer tray, blade and cups simultaneously. To do so, gently unscrew the
fastening nuts and, using them as a support, pull outwards and they will come loose so they
can be removed easily.
For a very thorough clean, disassemble the balls inside the squeezer tray (Fig. 10). You can
either put these parts in a dishwasher or wash them by hand. TAKE EXTRA CARE WITH
THE BLADE (Fig. 3) since it is very sharp and may cause injuries. It is advisable to put the
blade guard once it is clean, so you can continue to perform cleaning operations more safely.

Clean the front and the basket with a damp cloth.

Important Notice:

In case of damage due to improper cleaning, the warranty will not apply.
26