Stihl RE 362 Gebrauchsanleitung Seite 55

The cap has a standard thread and fits
all standard detergent containers.
Slide the intake hose as far as
N
possible into the detergent
container
Set the dosage
Select the detergent container
N
Detergent metering knob at setting
–
A = left container
Detergent metering knob at setting
–
B = right container
Set the dosage (possible
N
adjustment range 0% - 6%)
During use, always apply the
N
detergent from the bottom upwards
Detergent must not be allowed to dry on
the object to be cleaned.
If detergent is no longer to be added:
Set detergent metering knob to 0
N
Let the high-pressure cleaner
N
continue to run with the spray gun
open until no more detergent comes
out of the nozzle
RE 362, RE 362 PLUS, RE 462, RE 462 PLUS
After finishing work
Empty the detergent tank and rinse
N
it with clear water
Immerse the intake hose in clean
N
water
Actuate the spray gun and flush out
N
the residual detergent
Precisely calculating/setting the
detergent concentration
For a few detergents, the concentration
must be very precisely set. In this case,
measure water flow rate and
consumption of cleaning agent.
Set the nozzle sleeve to low-
N
pressure operation – as described
above
Set the detergent metering knob to
N
"0 % (min)"
Hold the spray gun in a suitable
N
empty receptacle (> 20 l) and
actuate for exactly 1 minute
Measure the quantity of water "Q" in
N
the container
Fill 2 liters of detergent diluted as
N
directed into a suitable container
(with a scale of 0.1 l) – STIHL
recommends the use of genuine
STIHL detergents
Hold the intake hose in the
N
container
Set the detergent metering knob to
N
the desired concentration: 0 %
(min) bis 6 % (max)
Hold the spray gun in a suitable
N
empty receptacle (> 20 l) and
actuate for exactly 1 minute
Read the detergent consumption
N
"QR" on the scale
Calculating the actual detergent
concentration:
QR
x V = concentration
Q
QR = amount of consumed
–
detergent (in l/min)
Q = Water without detergent
–
(in l/min)
V = Predilution of detergent (in %)
–
If the actual concentration deviates from
the desired concentration, reset dosing
knob and repeat measurement if
necessary.
Calculating the predilution of the
detergent in %
If the predilution is not indicated as a
percentage, it can be calculated using
the following table:
Ratio value
1:1 = 50 %
1:2 = 33.3 %
1:3 = 25 %
1:5 = 16.6 %
1:10 = 9 %
Example:
Calculation ratio of 1:2
A = 1
–
B = 2
–
English
53