Fitting, Removing Spray Lance; Fitting, Removing High-Pressure Hose - Stihl RE 362 Gebrauchsanleitung

Fitting, removing spray lance

1
Pull back and hold the coupling (1)
N
Push the spray lance (2) into the
N
mount on the spray gun, or pull it out
to remove the spray gun,
respectively
Release the coupling (1)
N
RE 362, RE 362 PLUS, RE 462, RE 462 PLUS
Fitting, removing high-
pressure hose
Machines without hose reel
Connecting the high-pressure hose
2
Push high-pressure hose onto the
N
connector (1)
Attach union nut (2) and screw it on
N
and tighten by hand
Disconnecting the high-pressure hose
Unscrew the union nut (2)
N
Pull high-pressure hose off of
N
connector (1)
Machines with hose reel
The high-pressure hose is already
connected at the factory.
Disconnecting the high-pressure hose
1
N
2
N
N
N
Connecting the high-pressure hose
N
N
N
N
3
1
Unroll the high-pressure hose (1)
Open the hose guide (2)
Unscrew the union nut (3).
Pull high-pressure hose (1) off of
connector
Push the high-pressure hose (1)
onto the connector of the hose reel
Attach union nut (3) and screw it on
and tighten by hand
Push the high-pressure hose into
the hose guide (2) and close the
hose guide.
Roll up high-pressure hose
English
47