Fitting, Removing Spray Lance - Stihl RE 98 Gebrauchsanleitung

Holders for power cord
5
5
Press the holders (5) for the power
N
cord into the mounts on the housing
– holders must snap into place
Connector on water inlet
6
Attach the connector (6) to the
N
water inlet by hand and tighten it
RE 98

Fitting, removing spray lance

Spray lance
2
Press the spray lance (1) into the
N
mount on the spray gun (2), turn it
by 90° so that it engages
Remove
Press the spray lance (1) into the
N
mount on the spray gun (2), turn it
by 90° and pull it out of the mount
Nozzle
4
Insert nozzle (3) in spray lance until
N
the safety latch (4) engages – at
which point the safety latch button
will spring out again – the adjustable
high-pressure nozzle has an anti-
twist device; orient this according to
the groove on the spray lance
Remove
Press the safety latch button (4) and
N
pull out the nozzle (3)
1
3
+
English
39