Operation Of The B-Control Units - b-intense b-control deluxe Bedienungsanleitung

Operation of the b-control units

Every b-intense infrared cabin is equipped with a control system which was developed
®
specifically for heat application through infrared heaters. The b-control operating panel is
always positioned close to the user seat. The control panel has a digital display. During the
entire application the values in your cabin can be read on this display as follows:
› Session runtime in minutes
› Current cabin interior temperature in Degrees Celsius
b-control deluxe
on/off
back
heater
front
heater
floor
heating
USB-port, loading station for external
ventilation
devices (tablet, smartphone, etc.),
musik playback via USB-stick
Starting up your b-intense
Press the power button
matically activated:
› The back and front heater active within 2–3 seconds. The front heater heats up to 80% of its output, the back heater to 50%. The front
heater can be adjusted at any time via the control panel. The back heater can be increased after the 5 minute warm-up phase and reduced
from the start. The limit of 50% during the first 5 minutes allows the body to adjust optimally and gently to the heat supply and to increase
the efficiency of the application.
› LED coloured light (only included in b-control deluxe control unit)
› Floor heating at 100%
display
light colour
selection
music
playback
volume
audio sources
infrared
programs
infrared cabin
®
for 1 second to activate your b-intense
b-control basic
on/off
display
back
heater
floor
heating
front
heater
infrared
programs
USB loading station for external
devices (tablet, smartphone, etc.)
® infrared cabin. By switching on, the following basic settings are auto-
47
EN
b-control single