Do not pull the power plug out of
the electrical outlet by the power
cord .
Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping and
splashing water .
Store the product in a cool, dry
place, protected from moisture
and out of the reach of children .
Protect the product against heat .
Do not place the product close to
open flames or heat sources such
as stoves or heating appliances .
Before first use
Remove the packaging . Check if all parts are
complete .
During production, some parts are covered with
a thin oil film for their protection . Before first use,
operate the product without any batter so that
any potential residues evaporate .
Clean the product and its accessories
(see "Cleaning and care") .
NOTES:
The first few times the product is heated up, a
faint odour may be present . Ensure sufficient
ventilation in the area .
Discard the first set of waffles/donuts .
10 GB
Assembly
m
WARNING! Risk of electric shock. Before
installing/removing the plates 11a 11b 12 13:
Disconnect the power plug 4 from the socket-
outlet .
DANGER! Risk of burns. Do not change/
remove the plates 11a 11b 12 13 right after
operation . Let the product cool first .
Installing the plates
Open the lock 1 . Open the product .
Place the inner catch 10 of the chosen plate into
the large hook catches 7 .
Push down the plate until it clicks in place .
Repeat on the other side of the product .
NOTES:
Install only plates of the same type .
Motif plate
Concave 11a
Convex 11b
Removing the plates
Open the lock 1 . Open the product .
Pull the release levers 8 . Remove the plate .
Repeat on the other side of the product .
Installation (Fig. B)
Bottom section of product
Upper section of product