Operation And Maintenance; Service, Repair - MICRO-EPSILON induSENSOR DTA-1G8 Betriebsanleitung

Operation and Maintenance

5.
Operating the gauges requires a suitable controller. Principally, the gauges must be adjusted together with
the controller before initial operation (refer to the relevant operating instructions for the controller).
The sensor housing must not be opened.
Unauthorized repair attempts result in the loss of warranty!
6.
If the sensor or sensor cable is defective, please send us
the affected parts for repair or exchange.
If the cause of a fault cannot be clearly identified, please
send the entire measuring system to:
induSENSOR, Series LVDT, Gauge
Operation and Maintenance
Do not grease or oil the gauge.
Clean the gauge by purging with compressed air.

Service, Repair

MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Koenigbacher Str. 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
info@micro-epsilon.com
www.micro-epsilon.com
Page 35