Safety; Symbols Used; Warnings - MICRO-EPSILON induSENSOR DTA-1G8 Betriebsanleitung

Safety

1.
System operation assumes knowledge of the operating instructions.
1.1
The following symbols are used in these operating instructions:
i
1.2
Avoid shocks and impacts to the gauge.
> Damage to or destruction of the gauge
Excitation voltage and excitation frequency must comply with the requirements for the sensor.
> Damage to or destruction of the gauge
> Inaccurate or incorrect measurements
Protect the sensor cable against damage.
> Destruction of the gauge
> Failure of the measuring device
Correctly lay the compressed air hose for gauges with pneumatic push (avoid kinks in the hose and do not
pull over sharp edges; comply with the permissible bending radius). Check the pneumatic system for tight
sealing.
> Loss of functionality
Supply the measuring gauges with pneumatic push with clean compressed air (free of oil, dust and water).
Install maintenance units with water and oil traps and with fine filters (5 µm).
> Loss of functionality.
induSENSOR, Series LVDT, Gauge
Safety

Symbols Used

Indicates a situation that may result in property damage if not avoided.
Indicates a user action.
Indicates a tip for users.

Warnings

Page 23