Troubleshooting - Panasonic ER-GC71 Bedienungsanleitung

Lubrication
• Apply the oil to the clipper before and after each use.
• Make sure that the clipper is turned off.
1
Remove the blade.
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the
main body, turn on the
power and allow to run for
approximately 5 seconds.
PB017706 - ER-GC63 53 _(01GB)_04-25-19.indd 17
Replacement parts
►
Replacement part is available at your dealer or Service
Centre.
Replacement parts
for ER-GC71/
ER-GC63/ER-GC53
• Do not use any blade other than the one dedicated as
it may cause defect in performance.
• We recommend Panasonic oil WES003.

Troubleshooting

ER-GC71
Perform the following actions.
If the problems still cannot be solved, contact the
store where you purchased the unit or a service
centre authorized by Panasonic for repair.
The blade has not
been cleaned
properly.
ER-GC63/ER-GC53
Makes a loud
sound.
The clipper has
become blunt.
ER-GC71:WER9615
Blade
ER-GC63/53:WER9605
Oil WES003
Problem
When the clipper is very dirty,
remove the blade and wash
with water. (See page 15.)
Confirm that the blade is
properly attached.
Replace the blade.
(See page 16.)
Clean the blade and apply oil.
(See pages 15 to 17.)
Action
17
2019/4/25 15:04:17