Panasonic ER-GC71 Bedienungsanleitung Seite 14

Shaping your sideburns
Without comb attachment
Holding the clipper with the power switch at the
bottom, keep the blade at an angle of 90° against
the sideburns and move the clipper from top to
bottom along the skin to trim the sideburns.
Trimming the downy hair around the neckline
Without comb attachment
Holding the clipper with the
power switch at the bottom,
touching the blade perpendicular
to the area of downy hair, and
move the clipper downward
along the skin.
14
PB017706 - ER-GC63 53 _(01GB)_04-25-19.indd 14
Trimming to an even length
Holding the clipper with the
power switch facing outwards,
trim slowly while crisscrossing
from various directions to
avoid missing any spots.
Notes
• It is recommended to ask someone else to trim
around your own ears and neckline.
• The desired results may not be achieved if hair is too
long. In this case, trim the hair to a length of about
2 cm before using the clipper.
Trimming beard
• Do not use with shaving foam applied or when the
beard is wet.
A wet beard may stick to the skin or bunch up, making
it difficult to trim.
• Before trimming, comb your moustache with a comb.
Trimming to an even length
90°
Holding the clipper with the power
switch facing outwards, trim by
bringing the blade in contact with
the skin and moving the clipper
against the flow of the beard.
• Hair trimmings may collect inside the
comb attachment when a large
volume of beard is cut, so discard hair
trimmings after each use.
2019/4/25 15:04:14