Troubleshooting; Removing The Built-In Rechargeable Battery - Panasonic ER-GP21 Bedienungsanleitung

Troubleshooting

Problem
Until problems are solved, please
follow each procedure as follows;
The clipper has become
1. Charge the clipper.
blunt.
2. Clean the blade and apply oil.
Operating time is short.
3. Replace the blade.
Clipper stopped
functioning.
4. Have the battery replaced by an
Push the main body into the charging
stand or appliance plug all the way.
The clipper cannot be
Charge within the recommended
charged.
charging temperature of 0 °C to
35 °C.
Apply oil.
(See page 12.)
Makes a loud sound.
Have the battery replaced by an
authorized service centre.
If the problems still cannot be solved, contact the store where you
purchased the appliance or a service centre authorised by
Panasonic for repair.
Action
(See page 10.)
(See pages 11 and 12.)
(See page 11.)
authorized service centre.

Removing the built-in rechargeable battery

Remove the built-in rechargeable battery before disposing the
clipper.
Please make sure that the battery is disposed of at an officially
designated location if there is one.
This figure must only be used when disposing the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it may cause malfunction.
• Remove the clipper from the AC adaptor.
• Slide the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps 1 to 8 and lift the battery, and then remove it.
• Take care not to short circuit the positive and negative terminals
of the removed battery, and insulate the terminals by applying
tape to them.
 




For environmental protection and recycling of materials
This clipper contains a Nickel‑Metal Hydride battery.
Please make sure that the battery is disposed of at an officially
assigned location, if there is one in your country.


13