Troubleshooting - Panasonic ER-GP30 Bedienungsanleitung

Lubrication
• Apply the oil to the clipper before and after each use.
Apply a drop of the oil to each
indicated point.
Attach the blade to the main
body, turn on the power and
allow to run for approximately
5 seconds.
Failure to apply the oil may
cause the following problems
due to rust, wear or burn out.
- The clipper has become blunt.
- Shorter operating time.
- Louder sound.
► Replacement parts
Replacement part is available at your dealer or Service Centre
Replacement parts for ER‑GP30
12
ER-GP30_EU.indb 12
Blade WER9701

Troubleshooting

Problem
Until problems are solved, please
follow each procedure as follows;
The clipper has become
1. Charge the clipper.
blunt.
(See page 10.)
2. Clean the blade and apply oil.
Operating time is short.
(See pages 11 and 12.)
3. Replace the blade.
Clipper stopped
(See page 11.)
functioning.
4. Have the battery replaced by an
authorized service centre.
Insert the appliance plug into the
clipper firmly.
The clipper cannot be
Charge within the recommended
charged.
charging temperature of 0 °C to
35 °C.
Apply oil.
(See this page.)
Makes a loud sound.
Have the battery replaced by an
authorized service centre.
If the problems still cannot be solved, contact the store where you
purchased the appliance or a service centre authorised by
Panasonic for repair.
Action
2016/05/06 17:51:46