Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Panasonic ER-GB44 Bedienungsanleitung

(private verwendung) akkubetriebener bartschneider
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 21

Troubleshooting

Perform the following actions.
If the problems still cannot be solved, contact the
store where you purchased the unit or a service
centre authorized by Panasonic for repair.
Problem
Until problems are solved,
please follow each procedure
as follows:
1. Charge the main body.
The main body has
2. Clean the blade and apply oil.
become blunt.
3. Replace the blade.
4. Have the battery replaced
The operating time
is short.
Charge the battery for
approximately 19 hours
continuously to rejuvenate it.
If few uses remain even after
charging, the battery has
The main body
reached the end of its life.
stopped working.
(Fluid may be leaking due
to degradation at the end of
battery life.)
Contact an authorized service
centre for repair.
18
Action
(See page 11.)
(See pages 15 to 17.)
(See page 17.)
by an authorized service
centre.
Problem
Push the main body into the
charging plug all the way
and make sure the charge
The main body
indicator lamp glows.
cannot be charged.
Charge within the
recommended charging
temperature of 0 °C to 35 °C.
The main body
When the main body is very
cannot be properly
dirty, remove the blade and
cleaned even after
wash with water.
water is poured
(See pages 15 and 16.)
from the water inlet.
Apply oil.
The main body
(See page 17.)
makes a loud
Confirm that the blade is
sound.
properly attached.
Action

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Er-gb43

Inhaltsverzeichnis