Using The Clipper - Panasonic ER-GC71 Bedienungsanleitung

AC operation
If you connect the AC adaptor to the clipper in the
same way as for charging, and turn on the power, you
can use it.
• If the remaining battery is too low, the blades may
move slowly or stop, even with the AC operation. In
this case, charge the battery for 3 minutes or more.
• The battery will be discharged, even with the AC
operation.

Using the clipper

• Make sure that the clipper is turned off.
• Apply the oil to the clipper before and after each use.
(See page 17.)
• The appliance may not operate in an ambient
temperature approximately 0 °C or lower.
1
Mount the desired comb attachment and adjust
the trimming height as needed. (See pages 12
and 13.)
• It can also be used without the comb attachment.
(Trimming height: approx. 0.5 mm)
2
Slide the power switch on the main
body to the " " position to turn on
the power.
Trimming hair
Trimming beard
12
PB017706 - ER-GC63 53 _(01GB)_04-25-19.indd 12
(See pages 13 and 14.)
(See pages 14 and 15.)
Removing and mounting the comb attachments
• Take care not to injure hands, etc., with the blade
when removing or mounting the attachment.
Removing the comb attachment
Hold the main body securely and remove
the comb attachment from the main body.
Mounting the comb attachment
Mount the comb attachment to the main
body until it clicks.
• If the comb attachment is not attached
correctly, it may shift and end up cutting
too much during use.
How to adjust the trimming height
• Make sure that the clipper is turned off.
Turn the dial and adjust the trimming height
indication mark ( a ) to the desired height.
ER-GC71/
ER-GC63
a
ER-GC53
2019/4/25 15:04:08