Herunterladen Inhalt Inhalt Diese Seite drucken

Function Button - sportplus S-BIKE Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für S-BIKE:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

FUNCTION BUTTON

FUNCTION BUTTON:
Use this button to select the functions time, speed, distance, calories and pulse.
Press and hold the button for 2 seconds to reset.
INSERTING THE BATTERIES
1.
Remove the battery compartment cover on the back of the monitor.
2.
Heeding correct polarity, insert 2 AAA batteries into the compartment and replace
the cover.
3.
If the display can no longer be read or if only some segments are visible, please
remove the batteries and wait 15 seconds before reinserting them. Dispose of
empty batteries properly in accordance with local regulations.
4.
The monitor display goes out when the batteries are removed.
FUNCTIONS AND OPERATION
AUTO ON / OFF:
The monitor turns on automatically when the home trainer is used. The monitor turns
off automatically when the pedals are not used for 4 minutes.
SCAN:
Press the MODE button until a triangle next to „Scan" in the upper left-hand corner of
the display appears. The LC display now shows all functions and values in succession.
Each function is shown for approx. 4 seconds.
TIME:
Automatically measures the time as soon as training begins.
SPEED:
Shows the current training speed.
DISTANCE:
Shows the distance covered during training.
CALORIES:
Shows the calories consumed during training. This is an approximate value.
PULSE:
Automatically registers and shows the corresponding heart rate during training.
Press the button until the arrow points to PULSE. The monitor now shows the current
heart rate per minute. To measure your pulse, place the palms of your hands on both
contact surfaces. The LC display then shows your current heart rate per minute.
Note: The heart rate monitor is intended as a training aid and not as a medical device.
If you feel unwell, please cease training immediately and contact your physician.
34
18. TRAINING
TRAINING TIPS
All recommendations in this manual are only intended for healthy persons and not for
persons with heart/cardiovascular problems!
All tips are intended only as rough suggestions for a training program.
If necessary, consult your physician for tips that meet your personal requirements.
The following pages will explain exactly how to operate your new training device and will
illustrate the fundamentals of fitness training. In order to reach your desired training goal,
it is imperative to inform yourself about important points for creating a training program
in general and about the exact way to operate your home trainer using this manual as a
guide. Therefore, please thoroughly read all of the points listed here and pay them close
attention.
DESIGNING A TRAINING PROGRAM
In order to achieve noticeable physical and health improvements, the following factors
have to be considered before determining the necessary training effort.
1. INTENSITY
The level of physical strain during training must exceed the normal burden without
reaching a point of breathlessness or exhaustion. A suitable guideline for effective training
is your pulse.
During training, it should be at a level between 70% and 85% of your maximum pulse.
During the first week, your pulse during training should remain in the lower 70% of your
maximum pulse. Over the course of the following weeks and months, your pulse frequency
should slowly increase to the upper level of 85% of your maximum pulse. The better your
physical condition becomes, the more your training efforts should be increased. This can
be achieved by increasing the training duration and/or increasing the difficulty level. If
you would like to measure and monitor your pulse frequency manually in addition to the
measurements carried out by the training computer on the home trainer, you can use the
following methods:
a) Pulse control measurement in the usual manner (e.g. feeling your pulse on your wrist
and counting the beats within one minute).
b) Pulse control measurement using suitable and calibrated pulse measurement
devices (available in a medical supplies store).
WARNING!
The pulse rate monitoring systems may be inaccurate. Over-exercise may
result in serious injury or death. If you feel faint stop exercising immediately.
35

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sp-ht-1003

Inhaltsverzeichnis