Safety Instructions; Malfunction Causes And Remedies - Silvercrest SNS 45 B4 Bedienungsanleitung

Safety instructions

WARNING
Observe the following safety information to avoid risks and property damage:
► Repairs to electronic appliances may only be carried out by specialists who
have been trained by the manufacturer. Considerable risk to the consumer
and damage to the appliance can occur as a result of incompetent repairs.

Malfunction causes and remedies

The following table will help with localizing and remedying minor malfunctions:
Defect
Appliance does
not switch on.
UV gel i does not
harden sufficiently.
After hardening,
a "sweat layer" re-
mains on the nails.
The artificial nails
are soft/loosened.
The artificial
fingernails show
unevenness.
A UV lamp does
not glow.
NOTICE
► If you cannot solve the problem with the aforementioned solutions, please
contact Customer Services.
SNS 45 B4
Possible cause
The plug is not connected.
Mains power socket does
not supply any voltage.
The selected treatment
time too short.
One or more UV lamps
are defective.
Too much UV gel i
applied.
The nails were not directly
under the UV lamps.
Occurence of a "sweat-
layer" caused by polyme-
rization.
Loosening of the artificial
nails by products with a
high acetone concentration.
Pressure on the brush 7
too high when applying
the UV gel i.
UV gel i unevenly applied.
UV lamp defect.
Solution
Insert the plug into the mains
power socket.
Check the fuses.
Select a longer treatment time.
Replace any defective UV lamps (see
chapter entitled "Exchanging UV
lamps")
Apply less UV gel i.
Hold the hand correctly in the
UV appliance 1.
Remove the "sweat layer" with
the finishing solution z.
Apply no products with a high
acetone concentration.
Do not press too hard on the brush 7
when you are applying the UV gel i.
Apply a further and thinner layer
of UV gel i and then harden it.
Replace the defective UV lamp.
GB │ IE │
63 ■