Matching A Nail Set; Application Of The Uv-Gel - Silvercrest SNS 45 B4 Bedienungsanleitung

Matching a nail set

Carefully file the transitions from the nail tips t to the natural nails with the
Sandpaper file r, until they conform to the contour of the natural nail. File
only the nail tips t! Do not damage your natural nail.
Carefullly file the sides of the nail with the Sandpaper file r until it is
straight and does not exhibit a "wing".
File the nail tip t first with the sandpaper file r and then with the sanding
block 8. The nail tip t should no longer shine.
Repeat this step for each individual nail.
Remove the dust from filing with a paper cloth or cellulose pad w.

Application of the UV-Gel

Using the brush 7, take a small amount of UV Gel i and then wipe the
excess on one side of the brush 7 off on the edge the UV Gel pot.
Apply a thin coating of UV-Gel i onto the complete nail. Apply a little
more UV Gel i to the lower part of the nail, as hereby is how the offset
between the natural and the artificial nail is created. Furthermore, the
transition from natural to artificial nails is especially sensitive to pressure and
knocks, thus more UV Gel i must be applied here.
INFORMATION
When you are doing the application do not press too heavily on the brush 7,
►
since the brush 7 could otherwise cause streaking.
Model the first layer of the UV Gel i very carefully, as this determines the
►
future shape of the nail. Model the best possible natural nail shape.
Maintain a distance of about 1 mm from the cuticle during the application.
SNS 45 B4
r
GB │ IE │
55 ■