Appendix; Technical Data - Silvercrest SMS 300 A1 Bedienungsanleitung Und Sicherheitshinweise

Fault
The suction power
is too weak.
The UV-C lamp
does not light up.
The vibration
7
head
vibrate.
An unpleasant
odour escapes
from the appliance
during suction.

Appendix

Technical data

Power supply
Power consumption
Protection class
Light bulb
Classification of the UV-C
lamp risk group
NOTE
► No user action is required to switch the product between 50 and 60 Hz.
The product adapts automatically to either 50 or 60 Hz.
■ 14 │ GB │ IE │ NI │ CY
Cause
The dust container
full.
The HEPA dust filter
dirty.
The suction opening
is blocked.
The automatic switch-off
device of the UV-C lamp
8
8
has been activated.
The UV-C lamp
appliance is defective.
The vibration function is
does not
not switched on.
Odours often develop
when new appliances
are used for the first time.
The appliance is
defective.
220 – 240 V ∼ (alternating current), 50 / 60 Hz
300 W
II /
6 W, G5, UV-C
Risk group 3
Remedy
3
is
Empty the dust container
4
is
Clean the HEPA dust filter
Turn off the appliance, pull out
9
the plug from the wall socket
and remove the blockage.
Check the safety switches
left and right (see section
Safety switches).
8
Contact Customer Service (see
or
section Service).
Press the vibration button
The smell should disappear
after the appliance has been
used a few times.
Switch off the appliance, pull
out the power plug from the
socket and contact Customer
Service (see section Service).
(double insulation)
3
.
4
.
0
w
.
SMS 300 A1