Zanussi ZOB21601XK Benutzerinformation Seite 17

STAINLESS STEEL OR ALUMINIUM OVENS
Clean the oven door with a damp cloth or sponge
only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive materials
as they can damage the oven surface. Clean the
oven control panel with the same precautions.
CLEANING THE DOOR GASKET
Regularly do a check of the door gasket. The door
gasket is around the frame of the oven cavity. Do
not use the oven if the door gasket is damaged.
Contact an Authorised Service Centre.
To clean the door gasket, refer to the general
information about cleaning.
REMOVING THE SHELF SUPPORTS
To clean the oven, remove the shelf supports.
CAUTION! Be careful when you
remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
1
Install the removed accessories in the opposite
sequence.
AQUA CLEAN
This cleaning procedure uses humidity to help
remove remaining fat and food particles from the
oven.
1. Put 300 ml of water into the cavity
embossment at the bottom of the oven.
2. Set the function:
3. Set the temperature to 90 °C.
4. Let the oven operate for 30 minutes.
5. Turn off the oven and let it cool down.
2
.
6. When the oven is cool, clean it with a soft
cloth.
WARNING! Make sure that the
oven is cool before you touch it.
There is a risk of burns.
REMOVING AND INSTALLING DOOR
The oven door has two glass panels. You can
remove the oven door and the internal glass panel
to clean it. Read the whole "Removing and
installing door" instruction before you remove the
glass panels.
The oven door may close if you try to
remove the internal glass panel before
you remove the oven door.
CAUTION! Do not use the oven
without the internal glass panel.
1. Open the door fully and hold both hinges.
2. Lift and turn the levers fully on both hinges.
17