Install The Hardware - Axis Q1602-E Installationsanleitung

Page 8

Install the hardware

Follow the instructions below to install the network camera.
Prepare the network cable
The provided network cable can be connected in several ways. The first option is to use the cable as
is, with the pre-mounted rubber gasket.
The second option is to use the provided plastic M20 cable gland, which must be used to achieve an
IP66 rating. Using any other cable gland may cause water to seep in and may damage the camera.
If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently force the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the supplied screwdriver.
Notes:
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.
Downloaded from www.Manualslib.com manuals search engine
AXIS Q1602-E/AXIS Q1604-E Installation Guide