Axis Q1602-E Installationsanleitung Seite 21

AXIS Q1602-E/AXIS Q1604-E Installation Guide
Unit connectors
Network connector - RJ-45 Ethernet connector (connected to PoE OUT at delivery). Supports
Power over Ethernet. Using shielded cables is recommended.
Power connector - 2-pin connector block used for power input (not used).
Audio in - 3.5 mm input for a mono microphone, or a line-in mono signal (left
channel is used from a stereo signal).
Audio out - Audio output (line level) that can be connected to a public address (PA)
system or an active speaker with a built-in amplifier. A stereo connector must be
used for the audio out.
SDHC memory card slot - A standard or high capacity SD memory card can be used for local
recording with removable storage.
To insert an SD card, lift the SD card cover on the rear of the network camera, and carefully insert
the SD card into its slot.
To remove an SD card lift the cover and gently push the card in and release it. The SD card will back
out of the slot where it can then be removed.
I/O terminal connector - Used in applications for e.g. motion
detection, event triggering, time lapse recording and alarm
notifications. In addition to an auxiliary power and a GND pin, it
provides the interface to:
• 1 digital output – For connecting external devices such
as relays and LEDs. Connected devices can be activated
by the VAPIX® Application Programming Interface (API),
by the output buttons on the Live View page or by an
Action Rule. The output will show as active (shown
under System Options > Ports & Devices) if the alarm device is activated.
• 1 digital input – An alarm input for connecting devices that can toggle between an open
and closed circuit, for example: PIRs, door/window contacts, glass break detectors. When a
signal is received the state changes and the input becomes active (shown under System
Options > Ports & Devices).
Downloaded from www.Manualslib.com manuals search engine
SD memory card slot
Pin 4
Pin 3
Page 21
1 2
Pin 2
Pin 1