Cleaning The Shaving Unit In The Jet Clean System (Pt927Cc Only) - Philips PT927CC Gebrauchsanleitung

english
36
Note: Make sure that the projections of the shaving heads fit
exactly into the recesses.
Put the retaining frame back into the shaving unit and
7
turn the lock clockwise.
Insert the lug of the shaving unit into the slot in the top
8
of the shaver (1). Then close the shaving unit (2).
Note: If the shaving unit does not close smoothly, check if you
have inserted the shaving heads properly and if the retaining
frame is locked.
Cleaning the shaving unit in the Jet Clean system
(PT927CC only)
The Jet Clean System cleans the shaving unit.
Preparing the Jet Clean system for use
Note: Fill the cleaning chamber before first use and when the
'fluid low' symbol flashes to indicate that the fluid level is too
low. When the fluid level drops below the minimum level, the
cleaning symbol and the 'fluid low' symbol start to flash and the
shaver holder returns to its starting position
Simultaneously press the release buttons on both sides
1
of the cleaning chamber (1). Then lift the Jet Clean
System off the cleaning chamber (2).
, The cleaning chamber remains behind.
Unscrew the cap from the bottle with Jet Clean solution
2
(HQ200) and remove the airtight seal.