Cleaning And Maintenance; Cleaning The Shaver In The Smartclean System - Philips S95 Serie Bedienungsanleitung

20
English
The length settings on the beard styler attachment correspond to the
remaining hair length after cutting and range from 1 to 5mm.
1 Attach the attachment to the appliance (‚click') (Fig. 27).
2 Slide the comb straight into the guiding grooves on both sides of
the beard styler attachment ('click') (Fig. 28).
3 Press the length selector and then push it to the left or right to
select the desired hair length setting (Fig. 29).
4 Switch on the appliance.
5 Move the appliance upwards while you exert gentle pressure.
Make sure the front of the comb is in full contact with the skin
(Fig. 30).
6 Clean the attachment after use (see ‚Cleaning and maintenance').
Using the beard styler attachment without comb
You can use the beard styler attachment without the comb to contour
your beard, moustache, sideburns or neckline to a length of 0.5mm.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off the beard styler
attachment. Do not pull at the sides of the comb (Fig. 31).
2 Switch on the appliance.
3 Hold the beard styler attachment perpendicular to the skin and
move the appliance downwards while you exert gentle pressure
(Fig. 32).
4 Clean the attachment after use (see ‚Cleaning and maintenance').

Cleaning and maintenance

The accessories supplied may vary for different products. The box
shows the accessories that have been supplied with your appliance.

Cleaning the shaver in the SmartClean system

SmartClean system Plus has two phases: the rinsing phase and the
drying phase (Fig. 33).