Philips PT927CC Gebrauchsanleitung Seite 45

Problem
The shaver does
not work when I
press the on/off
button.
The shaver is not
entirely clean after
I clean it in the Jet
Clean System.
Possible cause
Long hairs obstruct the
shaving heads.
You have not inserted the
shaving heads properly.
The rechargeable battery
is empty.
The temperature of the
shaver is too high. In this case,
the shaver does not work.
The cleaning fluid in the
cleaning chamber is soiled.
The cleaning fluid level is too
low. If the fluid volume in the
cleaning chamber drops below
the minimum level during the
cleaning program, the program
aborts.The cleaning symbol
and the 'fluid low' symbol flash
at intervals and the holder
returns to its starting position.
You have used another
cleaning fluid than the original
Philips cleaning fluid.
english
Solution
Clean the shaving heads one
by one (see section 'Cleaning
the shaving unit with the
cleaning brush' in chapter
'Cleaning and maintenance').
Make sure that the projections
of the shaving heads fit exactly
into the recesses (see section
'Cleaning the shaving unit with
the cleaning brush').
Recharge the battery (see
chapter 'Charging') or connect
the shaver to the mains.
As soon as the temperature
of the shaver has dropped
sufficiently, you can switch on
the shaver again.
Empty and rinse the cleaning
chamber (see section 'Cleaning
the shaving unit in the Jet
Clean System' in chapter
'Cleaning and maintenance').
Refill the cleaning chamber
with cleaning fluid up to
the MAX level (see section
'Cleaning the shaving unit
in the Jet Clean System'
in chapter 'Cleaning and
maintenance').
Only use Jet Clean solution
HQ200.
45