Philips PT927CC Gebrauchsanleitung Seite 38

english
38
, During this phase of the cleaning program, the cleaning
symbol starts to flash and the shaver is automatically
lowered into the cleaning fluid.
, The shaver automatically switches on and off several
times and moves up and down.
, The cleaning symbol flashes throughout the cleaning
program, which takes approx. 8 minutes.
, After the cleaning program, the battery symbol on the
Jet Clean System goes on to indicate that the shaver is
being charged.
Note: If you press the on/off button of the Jet Clean System
during the cleaning program, the program aborts and resets.
In this case, the cleaning stops flashing and the shaver holder
returns to its starting position. The shaver may still be wet and
dirty, because the cleaning program has not been finished.
Note: If you remove the adapter from the wall socket during
the cleaning program, the program aborts. The shaver
holder remains in its current position. When you put the adapter
back into the wall socket, the shaver holder moves to its highest
position.
Note: When the fluid level drops below the minimum level, the
cleaning symbol and the 'fluid low' symbol start to flash with
intervals and the shaver holder returns to its starting position
Cleaning the Jet Clean system
Empty the cleaning chamber and clean it thoroughly by
rinsing it with hot tap water every 15 days if you use the Jet
Clean System daily. Otherwise empty and clean the cleaning
chamber at least once a month.
Clean the outside of the Jet Clean System with a moist
1
cloth.
Never immerse the Jet Clean System in water, nor rinse it
under the tap.