Error Indicators - hanseatic HGVI4582C10J7714DS Gebrauchsanleitung

Page EN-36 Troubleshooting table
Problem
The dishes are not
completely clean.

Error indicators

Code
: It takes too long for the water
E1
to fill up
: The heating element is
E3
defective
: Water overflow
E4
: Internal fault
E8
: Internal fault
Ed
: Fault in the washing control
Ec
system
Possible cause
There are food scraps which
are encrusted onto the dishes.
The dishes have not been
stacked optimally.
You have selected the
incorrect dishwashing
programme.
The dishwasher detergent is
incorrectly dosed.
The water pressure is too low. Turn the water tap on completely.
The spraying arm can not
rotate unhindered.
The nozzles on the spraying
arm are blocked/calcified.
Solution
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked
(see "Connect the inlet hose" on page EN-29).
Ensure that the water pressure is correct. See "Techni-
cal specifications" on page EN-39.
Have the appliance examined and repaired.
Switch off the tap. Find the gap in the seal (or have
someone find it) and repair the leak (or have it repaired).
Have the appliance examined and repaired.
Have the appliance examined and repaired.
Have the appliance examined and repaired.
Solution
Soak dirty dishes prior to washing
the dishes.
Stack the dishes in such a way
that all parts can be reached by
the water jets (see "Loading the
dishwasher" on page EN-17).
Select the correct dishwashing
programme (see "Programme ta-
ble" on page EN-21).
Use the correct dosage of dish-
washer detergent (see "Pro-
gramme table" on page EN-21).
Ensure that no dishes are imped-
ing the motion of the spraying arm.
Clean the nozzles (see "Checking
and cleaning the spraying arms"
on page EN-27).