Installation - hanseatic HGVI4582C10J7714DS Gebrauchsanleitung

Page EN-30 Set-up, connection and initial start-up
Recess dimensions

Installation

NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
Use the screws supplied (i) or screws
■
of the same length.
Requirements:
• Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
• Maintain sufficient distance from the walls
and adjacent appliances. The measure-
ments of the recess must at least corre-
spond to the details in the diagram above.
90°
820 mm
580 mm
Inlet/outlet area
and electrical
connection.
450 mm
90°
80 mm
100 mm
1. Switch the fuse off.
2. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
(c)
3. Affix the enclosed condensation-protective
film (c) to the bottom of the work surface.
In this way, you will avoid damage to the
work surface as a result of hot steam
which may be emitted from the dishwash-
er if the dishwasher door is left open.