Degree Of Water Hardness; Adjusting The Water Hardness; Test Run - hanseatic HGVI4582C10J7714DS Gebrauchsanleitung

To adjust the door
– so that it is easier to access, turn the screws
in an anticlockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.

Degree of water hardness

Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the
pharmacy.
Water hardness in
your household in
°dH
0-5
6-11
12-17
18-22
23-34
35-55
1. Determine the relevant setting from the
table above.
2. Open the dishwasher door.
Set-up, connection and initial start-up
Water hardness in
the dishwasher
H1
H2
H3
H4
H5
H6

Adjusting the water hardness

Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
(1) (2)
1. Open the door.
2. Switch on the dishwasher using the
button (1).
3. Press and hold the P (2) button for as
long as required until the display shows
only the current water hardness:
4. Press and hold the P (2) button as often
as required until the display shows the
desired setting.
5. Switch the dishwasher off using the
button (1).
The hardness level setting is saved.

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
For the procedure, see chapter "Dishwasher
operation", from page EN-22.
Page EN-33
to .
H1 H6