BASIC SETTINGS
Initial Settings
After your steam oven is first plugged in or after a power failure, the clock display will
flash to indicate that the time shown is not correct.
The oven will not operate until the clock and the water hardness are set.
To set the clock and the water hardness parameter value proceed as described in the
following chapters.
Setting the clock
To set the clock, proceed as follows:
• Select the Clock Symbol with the Parameter selection keys
oven is first plugged in or after a power failure). The hours start blinking.
• Set the hours with ''+'' and ''-''keys
• Confirm the selection with the Confirmation key
• Set the minutes with the ''+'' and ''-''keys
• Confirm the selection with the Confirmation key
Hiding/Displaying the Clock
• Select the Clock Symbol with the Parameter selection keys
• Press the Confirmation key
sure that you press first the confirmation key).
To show the clock again, repeat the described procedure again.
Downloaded from
www.Manualslib.com
1
2
1
manuals search engine
188
12 30
3
4
4
.
1
.The minutes start blinking.
.
4
1
.
and the Cancel/Safety Block Key
Basic Settings
6
5
3
(not necessary if your
. The hours start blinking.
3
6
at the same (make
10