General Safety Instructions For Power Tools - FLORABEST FHL 900 D4 Originalbetriebsanleitung

GB
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
General safety instructions
for power tools
WARNING! Read all safety
directions and instructions.
Omissions in the compliance with
safety directions and instructions
can cause electrical shock, fire
and/or severe injuries.
Retain all safety directions and in-
structions for future use.
The term "Power Tools" used in the safety
instructions refers to mains-operated power
tools (with power cord) and to battery-op-
erated power tools (without power cord).
Work area safety
Keep work area clean and well
•
lit. Cluttered or dark areas invite ac-
cidents.
Do not operate power tools in
•
explosive atmospheres, such as
in the presence of flammable
Iiquids, gases or dust. Power tools
create sparks which may ignite the
dust or fumes.
Keep children and bystanders
•
away while operating a power
tool. Distractions can cause you to
lose control.
• The appliance is not for use by chil-
dren
26
Electrical safety
Power tool plugs must match
•
the outlet. Never modify the
plug in any way. Do not use
any adapter plugs with earthed
(grounded) power tools. Unmodi-
fied plugs and matching outlets will
reduce risk of electric shock
Avoid body contact with
•
earthed or grounded surfaces,
such as pipes, radiators, ranges
and refrigerators. There is an in-
creased risk of electric shock if your
body is earthed or grounded.
Do not expose power tools to
•
rain or wet conditions. Water
entering a power tool will increase the
risk of electric shock.
Do not abuse the cord. Never
•
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
When operating a power tool
•
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
If operating a power tool in a
•
damp location is unavoidable,
use a residual current device
(RCD) protected supply. Use of an
RCD reduces the risk of electric shock.
• Where possible, connect the equip-
ment only to a plug socket with a leak-
age-current-operated circuit breaker
(FI switch), with a rated current of not
more than 30 mA.
• If the power cable for this equipment is
damaged, it must be replaced by the