Falcon Classic Deluxe 110 Gebrauchs-, Installations- Und Wartungsanleitung Seite 55

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
14. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel fi xing
screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2 retaining
nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
15. To Change Oven Door Latch
Remove outer door panel (see 14).
Remove screws 'B' holding latch
assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
16. To Adjust an Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.
17. To Change Oven Door Seal
Open oven door.
The seal is held
in place by small
hooks on the
rear face. At the
corner pull seal
diagonally away
from the door
centre until that
hook is released.
Proceed to the next hook and release it in a similar way, and
so on. Use force if the hooks are stiff , as the old seal will be
discarded.
When fi tting new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door, and
proceed round the door snapping in each hook in turn.
18. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from grill roof, 2
screws and washers. Remove 2 screws and washers securing
the grill element front support. Remove the screws from the
grill elements.
Lift elements out carefully, disconnect the leads from the
element terminals noting their position. If it is not possible
to disconnect the leads in this way, pull cooker forward to
gain access to the rear, remove screws securing the electric
cover to the back sheet and remove cover and disconnect the
terminals from the rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.
19. To Remove Oven Inner Back.
Open RH oven door and remove the screws and washers
securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse order
making sure that the 4 screws and washers are fully tightened.
20. To Change Fan in Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove screws
securing the electric cover to the back sheet and remove
cover. Disconnect the 3 terminals connected to the fan noting
their position. Remove oven inner back (see 20). Hold the fan
blade and remove the centre nut (left hand thread) 2 brass
washers, fan blade and Circlip. Unscrew fan retaining nuts and
washers (3 off each) and lift the fan away from the rear of the
cooker. Fit new fan and reassemble in reverse order. Check
operation of oven.
21 To Remove an Oven element Thermal Cut-Out.
Disconnect from the electricity supply.
Pull the cooker for ward to gain access to the cover box. Undo
the cover screws and lift clear. The cutout is located on the
earth plate be side the oven element con nec tions. Disconnect
the cutout wir ing. Undo the fi xings that secure the cutout to
the earth plate and re move. Fit re place ment control and re-
as sem ble in reverse order.
55