Troubleshooting - Dräger Polytron 6100 EC WL Gebrauchsanweisung

en

Troubleshooting

Quality Substatus
Bits 6 and 7 Bits 2 to 4
0 7
1 0
1 1
1 2
1 3
1 4
1 5
1 6
2 0
11.3 Device status (DIAG_STATUS)
Meaning "Allgemeiner Status" according to NAMUR NE107:
F: Failure
C: Function Check
O: Out of specification
M: Maintenance required
Bit DIAG_STATUS
31 F: Failure
30 C: Function Check
29 O: Out of specification
28 M: Maintenance required
27 FAULTS_ELECTRONICS
26 FAULTS_SENSOR
25 INSTALLATION_CALIBRA-
TION
24 OUT_OF_SERVICE
23 OUTSIDE_LIMITS
PV Cause
NaN Warm-up phase 1 active.
Maintenance mode active.
Gas reading – (Bit not used)
Gas reading – (Bit not used)
Gas reading – (Bit not used)
Gas reading – (Bit not used)
Gas reading Calibration interval expired.
Gas detector is operated outside
the specified temperature range.
Gas reading Gas reading outside the measur-
ing range.
Gas reading – (Bit not used)
Gas reading – (No warning, no error)
General Cause
status
– –
– –
– –
– –
F Serious device fault, vari-
ous causes.
F Sensor not detected or
defective.
C Calibration or bump test is
being performed. Mainte-
nance mode active.
C Start sequence active.
Start sequence failed.
O Transmitted gas reading
below the minimum range.
Remedy
Wait for warm-up phase 1 to finish.
Exit maintenance mode.
–
–
–
–
Calibrate the gas detector.
Use weather protection kit (accessory) when
exposed to sunlight.
A Calibrate the gas detector.
B Change the sensor.
–
–
Remedy
–
–
–
–
A Restart the gas detector.
B Reset the gas detector to the factory
settings.
C Reset the sensor to the factory settings.
D Update firmware.
E Have the gas detector checked by
DrägerService.
A Check the sensor connection.
B Remove and reinstall the sensor.
C Change the sensor.
Finish calibration or bump test.
Wait for start sequence.
A Restart the gas detector.
B Have the gas detector checked by
DrägerService.
A Calibrate the gas detector.
B Change the sensor.
Dräger Polytron 6100 EC WL, Dräger Polytron Repeater ISA