Special Information - Clearaudio Emotion SE Bedienungsanleitung

User manual / Bedienungsanleitung

4. Special information

4.1 Maintenance
Emotion SE
• If the
mains supply.
• Every twelve months you can lubricate (only if you will recognize speed variations) the bearing
of the turntable platter with the delivered oil. In this case it is enough to put 4 or 5 drops of the
oil into bearing. Please take special caution to any damages of the power cord. Any damages
should only be repaired only by authorized personal. A damaged power cord must be exchanged
immediately!
Caution !
Please use only non alcoholic fluids and only fluids specially used for acrylic, to clean the
Emotion SE
turntable. Otherwise damage to the material or surface could occur!!
4.2 Transportation
Emotion SE
Send / ship the
Only in the original packing Clearaudio can provide the warranty. If you repackage the turntable,
please make all steps inverted like at installation and set up (chapter 3)
• If any transportation of the
turntable platter. Otherwise serious damage can occur!
• The bearing hole needs to be covered as well, to avoid any dust coming into the bearing. Always
take of the pulley of the motor unit as well, to prevent the motor shaft from any damages.
4.3 Service
In case of any necessary service for all Clearaudio products should be done by authorized personal
only.
In case of any repair, the Clearaudio
authorized dealer or directly to the Clearaudio factory.
Made in Germany
turntable is a longer time not in use, please disconnect the motor from the
turntable always and only in the original packing!!!
Emotion SE
turntable should be necessary, please always remove the
Emotion SE
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Phone: +49 9131 40300100
Fax: +49 9131 40300119
www.clearaudio.de
www.analogshop.de
info@clearaudio.de
turntable needs to be send to your nearest
Germany
15