Clearaudio Emotion SE Bedienungsanleitung Seite 13

User manual / Bedienungsanleitung
3.2 Adjustment of the Antiskating
alignment of the antiskating
minimal antiskating
medium antiskating
maximum antiskating
Illustration 1 :
Minimal antiskating
(Screw is almost
removed)
Pic. 11: Antiskating adjustment
3.3 Setting-up of the motor
Take the motor-pulley out of the accessory bag and shift the
motor pulley as far as on the motors shaft until you have a
distance of approximately 1 mm between the upper edge of the
motor and the lower edge of the pulley.
Now tighten the three screws in the pulley one after the other
with the precision screw driver.
Now place the motor unit into the stainless steel motor stand and fix the motor with the two screws
on the side of the motor stand. Place the motor unit into the cut out on the left side of the turntable
chassis and pay attention, that the switch of the motor faces outside.
Now you can connect the power cord to your power outlet.
Place one drive belt around the platter and
around the pulley.
The smaller diameter of the pulley is used
for 33 1/3 rpm and the larger diameter for
45 rpm.
The position „I" on the motor-switches the
motor on.
Before first use, let the turntable run in for the first 15 to 30 minutes.
Made in Germany
tracking force
10 - 15 mN
15 - 20 mN
20 mN and more
Illustration 2 :
Medium antiskating
(Screw is at half
position)
Pic. 13: Drive belt mounting
posiion of the antiskating screw
see illustration 1
see illustration 2
see illustration 3
Illustration 3 :
Maximum
antiskating
(Screw is screwed
in)
1 mm
Pic. 12: Mounting the pulley
13