Clearaudio Emotion SE Bedienungsanleitung Seite 12

User manual / Bedienungsanleitung
Pic. 11: Top view: cartride body aligned to the
pringted lines
If you have to change the position of the diamond tip you can unscrew the allen screw on the top
of the tonearm`s headshell and move the cartridge into the corresponding position.
Please make also sure that the leading edge of the cartridge is parallel to the marker lines of the
cartridge alignment gauge. Fix the right position through looking the headshell screw on the top.
During final tonearm and cartridge installation, always take a look from the top onto
the alignment gauge, to avoid any parallax errors.
Pic. 12: Correct installation
After setting up the cartridge, please tighten the tonearm in its base to fix it in this position.
12
Lift down the cartridge and place the diamond tip of
the cartridge on the reference point on the
gauge
and make sure that the edges of the tone-
arm tube and the cartridge are absolutely parallel to
the marking lines printed on the cartridge alignment
gauge.
For that adjustment it is necessary to take a look di-
rectly from the top on the tonearm and the alignment
gauge.
The installation is done correctly, when at the same
time the armtube is parallel to the marking lines on
the gauge, the diamond tip is on the reference point
and the leading edge of the cartridge is parallel to the
lines on the gauge. Finally lock all screws that had
been involved during the adjustments.
Now you are ready for the anti-skating adjustment.
This also depends on the tracking force of the cart-
ridge and the diamond shape.
© clearaudio electronic GmbH, 2017/11
alignment