Inhaltsverzeichnis
Werbung
40
Downloaded from
www.Manualslib.com
3
1
2
manuals search engine
GB
Using of thermoprobe
Electronic programming device Logic control
allows switching off an oven after achievement of
desirable temperature inside of a dish. For this
purpose it is used a thermoprobe, which is
entering in the complete set of your oven.
For using the thermoprobe:
•
Insert the detachable connector of the
thermometer against the stop into a slot
inside of the oven. On the display will be
highlighted a temperature and a symbol 3
start blinking
Turn the knob of the oven operating
•
functions to choose a necessary mode.
Thus on the display will be lighting the
symbolical designation of a mode.
According to the chosen mode, the oven will
automatically
establish
temperature and on the display appears a text
„Oven ... °C". After installation of the necessary
temperature of coocking on the display will be
lighted „Thermoprobe:.. 00°C" for installation of
desirable temperature inside of a dish.
Press keys 1 or 2 (
•
temperature.
In 3 seconds the established parameters will be
remembered and an oven will be switched off.
Important! While on the display flash an
inscription "Thermoprobe: 00°C", the
oven waits for introduction of parameters!
If everything installed correctly, on the display
should be displayed:
- actual temperature inside of a dish,
- the established temperature inside of the dish,
- the established temperature inside of the oven.
the
recommended
-
+
or
) to set the
Werbung
Inhaltsverzeichnis
