Inhaltsverzeichnis
Werbung
18
Downloaded from
www.Manualslib.com
3
5
4
2
1
manuals search engine
MULTIFUNKTION OVEN CONTROL
Oven operation functions are controlled by the
knob 1 ON/OFF and knob 2 operation mode set
up on the control panel.
The graphic symbols on the knobes indicate the
selected operation modes.
To switch off the oven, set up the knob 2
operating mode and the knob 1 ON/OFF in
position „0".
For more comfort, you can use the electronic
programmable control 4, which enables to run
1
the oven in automatical, half automatical or
manual cycle.
Important! The activation of the oven is
indicated by yellow 3 and red 5 control
lights.
After the selected oven temperature has been
achieved, the red control light goes out.
2
If it is necessary to put the dish into a pre-heated
oven, do it after the red control light has gone out.
The red control light can also be on if the knob is
set in the position to illuminate the oven. In this
position, however, the heating element of the oven
is off.
If the control panel of your oven is equipped with
sunk knobes Push, to control the heat supply:
•
Push the knob slightly and let it go
The knob will come out of the control panel.
To countersink the knob:
•
Push the knob as far as it will go and let it
go.
* for models with control electronic programmable control
and programmer
EN
Werbung
Inhaltsverzeichnis
