Toshiba VN-M150HE Bedienungsanleitung Seite 9

12
15
14
13
11
UNIT LOUVER button (Unit / Louver select button)
Used for selecting a unit while changing settings if
the remote controls two or more units.
UNIT button:
If two or more indoor units are controlled by one
remote controller, use this button to select a unit to
adjust its air blow direction.
LOUVER button (*1): (4-way cassette type 2H
series only)
Selects a louver to control when adjusting the
louver lock setting or wind direction setting
separately for each louver.
12
button (Temperature set button)
Adjusts the set temperature.
Select the desired set point by pushing
or TEMP.
13
button (Ventilation fan speed button)
Used to select the ventilation fan speed
You can stop 24-hour ventilation temporarily by
pressing and holding the button for 4 seconds
while is displayed.
15-EN
11
14
button (Ventilation mode button)
Used to select a ventilation mode.
15
button (Filter elevating button) (*1)
* This function is not available.
OPTION:
Remote controller sensor (*1)
Normally the temperature sensor of the indoor unit
senses the temperature. The temperature around the
remote controller can also be sensed. For details,
contact your dealer.
* Do not use the function when the air conditioner is
controlled in a group.
TEMP.
(*1):
This function is not available for Air to Air Heat
Exchanger.
" " will be displayed for few seconds when the unit is
running in a system equipped with only the Air to Air
Heat Exchanger.
◆ Display section
All indicators are displayed on the display example below for explanation. In
reality, only the selected options will be displayed. Indications concerning
controlling the Air to Air Heat Exchanger are explained here. For indications
concerning an air conditioner, refer to the owner's manuals supplied with the
air conditioner.
• blinks on the display of the remote controller when the power switch
is turned on for the first time.
The initial settings progress while
controller after has disappeared.
NOTE
The LCD may temporarily be blurred due to static electricity.
3
4
5
1
SETTING indicator
Displayed when setting the timer or other
functions.
2
Operation mode indicator (*1)
Indicates the operation mode selected.
3
Error indicator
Displayed when the protective device activates or
an error occurs.
4
Time indicator
Indicates time concerning the timer.
(Indicates a error code when an error occurs.)
5
Timer mode indicator
Each time you press the button, the
indication changes as follows:
, , and no timer indication.
– 8 –
is blinking. Start to use the remote
2 8 9 7 10
6
1
6
Filter indicator
Reminder to clean the air filter.
7
Test run indicator
Displayed during a test run.
8
Louver position display (*1)
Indicates the louver position.
* Only for 4-way cassette, 1-way cassette, 2-way
cassette, under ceiling types
9
Swing indicator (*1)
Displayed during up/down movement of the
louver.
10
Set temperature display (*1)
The selected set temperature is displayed.
,
Display
section
Operation
section
EN
16-EN