Malfunctions, Causes And Solutions; Malfunctions During Operation - Silvercrest SKMH 1100 A1 Bedienungsanleitung

Downloaded from www.Manualslib.com
RP93471 Küchenmaschine mit Heizung LB5 Seite 99 Donnerstag, 14. August 2014 3:36 15

11. Malfunctions, causes and solutions

11.1 Malfunctions during operation

Malfunction
Appliance fails to start Blender jug 6 is not correctly
positioned
Lid 25 of the blender jug 6
is not correctly positioned
No power supply
Incorrect power supply
There is liquid Blade assembly 20 is not
underneath the correctly seated and is
appliance leaking
The seal of the blade
assembly 19 is defective
Liquid has escaped from the
blender jug 6 and has
drained through the base
unit's overflow hole 17 onto
the underlay (see
"6.9 Overflow" on
page 87)
Liquid is leaking from the Seal 24 is not correctly
lid 25 of the blender positioned
jug 6
Seal 24 is defective
SKMH 1100 A1
manuals search engine
Cause Solution
Position the blender jug 6 correctly
(see "7.3 Positioning the blender
jug" on page 88)
Position the lid 25 correctly (see
"7.5 Positioning the lid of the
blender jug" on page 89)
Check the plug and if necessary
also the fuse
Make sure to use the correct power
supply (see "6.1 Connecting the
power supply" on page 85)
Position the blade assembly 20
correctly (see "7.2 Inserting and
removing the blade assembly" on
page 88)
Install a new seal 19 (see
"10.6 Ordering seals" on
page 98)
When blending liquids on level 10
or using the pulse button 9, do not
exceed a quantity of 1 litre in the
blender jug 6, otherwise liquid may
spray out. At speeds lower than 10,
the blender jug may contain up to
2 l.
Position the seal 24 correctly (see
"10.3 Cleaning the accessories" on
page 97)
Install a new seal 24 (see
"10.6 Ordering seals" on
page 98)
99