Operation - Panasonic EY7460 Bedienungsanleitung

NOTE:
If excessive play occurs in the chuck,
secure the drill in place and 1 open
the chuck jaws by turning the lock collar
and 2 tighten the screw (left-handed
screw) with a screwdriver by turning
it counterclockwise (viewed from the
front).
Attaching or Removing
Battery Pack
1. To connect the battery pack:
Align the highlighted marker points and
attach battery pack.
Slide the battery pack until it locks
●
into position.
Alignment marks
2. To remove the battery pack:
Push down the button and slide the
battery pack forward.
EY7460_EY7960_Book.indb 7
Downloaded from www.Manualslib.com
Button
manuals search engine
Support handle
Place the support handle at your
favorite position and tighten the handle
securely.
Tighten
Loosen
Remove the handle when placing the
tool in the storage case.
IV. OPERATION
[Main Body]
Switch Operation
1. The speed increases with the amount
of depression of the trigger. When
beginning work, depress the trigger
slightly to start the rotation slowly.
2. A feedback electronic controller is used
to give a strong torque even in low
speed.
3. The brake operates when the trigger
i s r e l e a s e d a n d t h e m o t o r s t o p s
immediately.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled
for the first time after installing a new
battery pack or after the tool has not
been used for at least 1 minute (or
at least 5 minutes when the LED is
on). Rotation will start without any
lag during second and subsequent
operations.
- 7 -
2013-12-2 16:12:20