Blowing; After Finishing Work; When Work Is Finished; Emptying The Container - Stihl SE 33 Gebrauchsanleitung

English
9.4

Blowing

The wet/dry vacuum cleaner can also be used to blow off dirt
and dust from hard to reach spots.
► Remove the suction hose from the suction connector.
2
1
► Insert the suction hose (1) into the exhaust opening (2).
► Switch the wet/dry vacuum cleaner on.
► Hold the suction hose in one hand and blow the dirt off
either directly or via an attached accessory.

10 After Finishing Work

10.1 When Work is Finished

► Switch off the wet/dry vacuum cleaner and pull the mains
plug out of the socket.
► Empty the container.
► Detach the accessory and clean it.
► Clean the wet/dry vacuum cleaner.
34
2
1
4
► Roll up the connecting cable and hang it on the holder (1).
► Wrap the suction hose around the vacuum cleaner and
fasten it at the holder (3).
► Fasten the accessories at the holders (2) or holders (4).

10.2 Emptying the Container

► Switch off the wet/dry vacuum cleaner and pull the mains
plug out of the socket.
► Release the container locks.
► Lift off the top part.
► Empty the container and dispose of its contents in
accordance with the applicable regulations.
► If the filter bag is inside the container: Remove the filter
bag and dispose of it in accordance with the applicable
regulations.
► If liquids have been picked up:
► Allow the cartridge filter or foam filter element to dry.
► Replace the top part in position.

11 Transporting

11.1 Transporting the Wet/Dry Vacuum Cleaner

► Switch off the wet/dry vacuum cleaner and pull the mains
plug out of the socket.
► Empty the container.
10 After Finishing Work
2
3
0458-889-9621-A